Creality

Creality BLTouch Auto Bed Level Kit

$65.00 - $69.00
account.wishlists.heading

Create Wishlist

Close
Version *

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

Creality BLTouch auto bed leveling kit.

Included in the box:

  • Kit for Version 1 Control Boards (Ender, CR-10)
    • Official Antclabs BLTouch Sensor
    • bracket to attach to printer
    • required cables
    • required breakout boards and burner (Pin 27)

OR

  • Kit for Version 2 Control Boards (CR-10S)
    • Official Antclabs BLTouch Sensor
    • bracket to attach to printer
    • required cables

OR

  • Kit for CR-10-v2/v3 Printer
    • Official Antclabs BLTouch Sensor
    • bracket to attach to printer
    • required cables
    • instruction sheet

OR

  • Kit for Ender3 v2 Printer
    • Official Antclabs BLTouch Sensor
    • bracket to attach to printer
    • required cables

OR

  • Kit for Ender 6 Printer
    • Official Antclabs BLTouch Sensor
    • required cables

Buy a Creality BLTouch kit for your 3D Printer from Spool3D online in Canada without the surprise cost of the exchange rate!

SKU: CREALITY-BLTOUCH

Reviews

4 out of 5 (based on 4 ratings)
leave a review

Bltouch

5/5
Part kit came complete and the instructions were easy to follow. Shipping updates were timely. Will be dealing with spool3d again.
Posted by Rick, February 24, 2021

Ender 3 v2 BLTouch

5/5
The kit works great although I find the directions leave much to be desired. That is what Youtube is for however. I've used this with Pronterface to help dial in my bed leveling to precise measurements and my prints are coming out great.
Posted by Thomas Hasenack, February 18, 2021

Ender 3 BLtouch

5/5
The kit itself works great, but beware the software takes some work. With a little searching you can find solutions to any problem you will come across. I used pronterface and direct linked to my printer to set my Z. Would buy again
Posted by Justin, May 11, 2020

Creality BLTouch Auto Bed Level Kit

1/5
This will NOT work on an Ender 3. The biggest problem is the Pin 27 Adapter you need to plug the LCD and pin out from the BLTouch into does not work. The LCD pins are reversed completely. I had to buy this to make it work: https://www.amazon.ca/gp/product/B07L2Q2SSD?ref=ppx_pt2_dt_b_prod_image Once I received the new adapter all I had to do was reverse the ground and vcc pins with dupont male/female adapters (temporary, making sure this works) and I am now on my fourth successful print. I also received the V3.1 BLTouch. Uplaoded the right firmware and no issues. Maybe this batch of adapters was put together incorrectly, all I know is I had to shell out another $40 from Amazon to make it work.
Posted by David Pattee, July 19, 2019