TL;DR; Rip off the SPV on the part and inspect it as soon as you get it. I ordered this plate in September of 2023 so It's on me for not finding this out until literally last week. The only reason this is getting a three-star and not a two is that I didn't check it closely when I received the plate and I should know better so that's on me. First of all, I like the fact this product is at this price. I'm happy I didn't have to source aluminum cast pate and do work on it. With that said, the debur job was bad I had to run a debur tool down the edges on one side so I'm assuming the bit was dull but it's still not an excuse. There is also a single divot on the top surface like someone dropped a ball on it or hit it with a ballpen hammer. There are also lots of water/coolant spots on the top surface, from my perspective I paid for a product to not have to do extra work, and for my trouble, I get something that looks like ass. If I ok'd this part as the one making it I would be embarrassed by my work. All that out of the way, it will work fine in this instance I have a magnet on top of the bed for my spring steel sheets so I cannot see the blemishes, and it shouldn't affect print accuracy. I am disappointed in whoever produced THIS part, the next 100 will most likely be fine so I would still recommend buying this.

This is a great quality bed available in Canada. I am greatful that Spool3D has Voron parts available for us since most suppliers seem to have dropped support for build parts in favour of kits. My only gripe would be the lack of a threaded hole for use with a thermal fuse. The use of that safety item should not be overlooked.