Description
Free shipping in Canada for orders over $140 before tax. (via Canada Post)
T8 anti-backlash nut for 8mm threaded rod. Fit T8 lead screws sold by Spool3D.
Please ensure the lead of the nut and screw match.
Please read our post about lead vs pitch.
Package Contents:
- T8 anti-backlash nut
- Pitch: 1mm for 1mm lead; 2mm for 2, 4, 8mm leads
- Lead: Customer specified at 1mm (1 start) , 2mm (1 start), 4mm (2 start) , 8mm (4 start) , or 16mm (8 start)
Pitch = distance between threads
Lead = travel in mm for one revolution
Buy an anti-backlash T8 nut from Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!
4 Reviews
-
Leadscrew nut
I said the specific printer I was buying the nut for in the comments of my order and I did not choose the right one. The guys were nice enough to change my order to the correct nut before shipping it to me ! Thank you so much !
-
Not so great
The lead screws are straight and work well. But the anti back lash nuts are a 50/50 one works well and the other does not. The holes are also not threaded for attaching to the z gantry. I would look some where els for back lash nuts.
-
Poor machining
These nuts are poorly machined and need a lot of working in before you can even spin them by hand. Even with a healthy coating of grease they are quite stiff until you've run them up and down the lead screw quite a few times, and there were multiple burrs that needed to be removed by hand. The fastener holes are also not aligned with the shaft, so tightening them fully puts the nut at an angle and will bind the lead screw.
-
Work great
They need to be "primed" to slide properly, but they work great after that. I put the screw in a drill and get the assemblie to move on high speed couple of time before installation.