So Far, So Good
5/5
Direct swap for the E3D thermistors I was using. Went through a few of those due to improperly secured wires and them being a little fragile. Running on 2 different machines, all good.
*Spool3D Thermistor Cartridge - Semitec 104NT-4
$11.00
Current Stock:
286
Free shipping in Canada for orders over $140 before tax. (via Canada Post)
A custom made thermistor encapsulated into an easy to use cartridge package.
Using Semitec 104NT-4 thermistors, which are then potted into a cylindrical stainless steel with a high conductivity ceramic based adhesive. The legs are insulated with fibreglass sleeving, and terminated with a Molex Microfit 3.0 connector.
Compatible with E3D heater blocks and extension cables.
Semitec 104NT-4-R025H42G Datasheet
- Type 5 in Marlin firmware
- -50c to 300c range
- R25 = 100kohm
- B = 4267
- Cartridge dimensions: 3mm OD x 15mm
Package Contents:
- Spool3D thermistor cartridge with molex micro-fit 3.0 connector for easy replacement
- 85cm fiberglass sleeved cable with Molex Microfit connector and JST XH2.54 connector
Buy a Spool3D NTC100k thermistor cartridge from Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!
SKU:
S3D-104NT-4-THERM
