Bondtech LGX® Lite Large Gears eXtruder

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

The Bondtech LGX® Lite is a filament feeder based on the LGX® Large Gears eXtruder and uses Bondtech’s new Dual Drive Technology based on larger drive gears.

Each LGX® Lite extruder is supplied with:

• 1x LGX® Lite feeder;
• 1x LDO Nema14 Round 20mm pancake stepper motor;
• 1m long lead cable
• with JST-XH 4-pin connector
• 1x 2mm Hex Key (recommended tool);
• 1x Powered By Bondtech sticker.

Also shipping with additional accessories:

• 1x Push-fit collar
• 1x 30mm PTFE tube to use in the PTFE Tube Adapter.
• 8x M3 square nuts for reinforcing mounting holes.

8 features of this Bondtech eXtruder:

• Larger drive wheels, for increased filament grip;
• Filament pre-tension lever, for repeated results;
• Drive wheels’ maintenance windows, for easy cleaning;
• Compact, light & centered filament path, for increased performance and compatibility;
• Multiple mounting hole patterns, for easy and flexible setup;
• Compatible with Nema14 round stepper motors;
• Craft boxes without bleaching & no coating.
• Nylon housing with no dyeing or other chemical post processing.

3D Printed Housing using PA12

The housing parts are professionally printed with polyamide 12 for maximum strength, precision and higher temperature resistance.

Technical Specification
LGX® LITE EXTRUDER

• e-steps value : 562 using 16 microsteps; 1124 using 32 microsteps.
• Drive wheels : hardened steel;
• Materials compatibility : abrasive; rigid; semi-flexible; flexible; and soft.
• Mounting holes : M3
• Mounting patterns : bottom (4 points); right (2 points), front to motor (2 points), top (1 point)
• Hole at the top of the LGX® Lite : 5 mm depth
• Holes on the side of the LGX® Lite : 5 mm depth
• Holes on the bottom of the LGX® Lite : 5 mm depth
• Max tightening torque on the extruder screws is 0.3 Nm

CUSTOM STEPPER MOTOR FOR BONDTECH LGX™

• Connector: JST-XH 4-pin connector
• Motor gear : 10 teeth
• Motor length: 20 mm
• Motor Diameter: 36mm
• Weight : 93g
• Max Current : 1.0 A / phase
• To use the LGX, run the stepper motor with currents between ~0.45 and ~0.65A:
• Be vigilant regarding the stepper motor surface temperature.
• Keep it cool enough to touch. Lower Vref otherwise.
• Leads Length : 1m
• Step Angle : 1.8 degree
• Max Torque at : 1800 PPS
• Potential Flow Rate @ Max Torque : 120mm^3/s
• Class: H, rated peak temp 180℃
• Max operating Temperature / Current : 120℃ / 750 mA
• Manufacturer : LDO
• Manufacturer SKU : LDO-36STH20-1004AHG(XH)
• Check for more info here.

Buy a Bondtech LGX® Lite Large Gears eXtruder from Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!