3M

3M 468MP x 5mil Adhesive Sheet - 305mm x 305mm (12 inch x 12 inch)

$7.00

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

 

3M 468MP clear transfer tape uses an acrylic adhesive and can be used in the following temperature range: 5 C to 200 C.   This adhesive tape has a 5 mil thickness. Products in this category features liners which you peel away to expose the adhesive material before applying to the 3D printer bed or PEI (polyetherimide)sheet.

This product is too large to send by lettermail.

Key Features:

  • 5 mil (0.0052") thickness
  • Heat resistant and durable

Buy 3M 468MP x 5mil adhesive sheets from #Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!

Current Stock: 244
SKU: 468MP-305X305

Reviews

5 out of 5 (based on 5 ratings)
leave a review

This stuff sticks like a bad police record!

5/5
It's fantastic for putting the PEI sheet on, just be careful to place it right the first time cause just like life, there's no second chance!
Posted by Bryan Denny, December 12, 2018

Great for PEI on Glass

5/5
My glass and PEI are firmly together now. Exactly what I was looking for. Not to hard to apply, just take you time and apply like a giant cell phone screen protector
Posted by Jordan Stella, May 31, 2017

Good stuff

5/5
Great for PEI, tricky to apply.
Posted by Romain Grangier, April 08, 2017

Sticks like white on rice.

5/5
Bought it to stick my PEI sheet to a glass plate, because the pei sheet had a slight warp and wasn't clipping flat onto my print bed. It is extremely sticky and goopy. About 0.5 mm thick when applied. Impossible to remove without destroying it. When applying, use proper techniques to avoid bubbles. Heats up without losing its stick, and stretches slightly to accommodate thermal expansion when hot.
Posted by undefined, November 14, 2016

Great for PEI sheet

5/5
Works great for attaching PEI sheet to heated bed. Use a credit card when applying to minimize bubbles.
Posted by Josiah, October 17, 2016