Voron 2.4 Kinematic Bed Mount

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

Voron 2.4 Kinematic mounts by Lightweight Labware (Whoppingpochard)

These are the laser-cut V2.4 kinematic bed mounts, meant to limit the effects of heat on your aluminum build plates, otherwise known as the taco effect. 

This is the stainless steel version.

Comes with all the fasteners you need to get this up and going.

Please note: this raises the bed height approx 8mm, you may need a longer pin for your Z end stop (e.g. 35mm pin vs 30mm).

For additional information as well as installation instructions see here.

Note: this design relies on the stock 150 mm bed support extrusion spacing. There have been reports of some AliExpress kits shipping beds with different mount spacing. Please check your printer before ordering!

Buy a Voron 2.4 kinematic bed mount in Canada without the surprise cost of the exchange rate!