Free shipping in Canada for orders over $140 before tax. (via Canada Post)
This kit allows the use of existing E3D hotends. E3D makes a fantastic product, and we aren’t going to reinvent that wheel. This uses the same mounting hole pattern as the E3D extruder, and also has a couple mounting holes in the front (please see drawing). It includes a PTFE tube cut to length for the E3D v6 hotends. So you’ll have all the same advantages of precision, supported, reliable filament driving with the flexibility to print at much higher temperatures.
Please see the Flexion support page for information on retrofitting to your printer.
- Mounting block and mounting hardware
- 2 mirrored Flexion extruder drives
- Tensioning arm with idler and cleaning brush
- Adjustment cam
- Drive gear
- Nozzles: 0.3, 2 x 0.4, 0.5, 0.6, and 0.8 mm orifice
- PTFE feed tubes
- Spare cleaning brush
- “Flexion inside” quick-guide sticker
Dual E3D mount. Includes the mounting block and clamp plates, two mirrored Flexion Extruder drives, PTFE tubes for E3Dv6 hotend, and 6 nozzles: 0.3, 2x 0.4, 0.5, 0.6, 0.8. Does NOT include the E3D hotend, as pictured.
Note: does not include E3D hotend, stepper motor or motor mounting screws
Buy a Flexion Extruder Kit from #Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!