*E3D Volcano Hotend - 1.75mm

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

Original Prusa printers require the Prusa heatbreak if you use the MMU system - https://spool3d.ca/prusa-e3d-v6-heat-break/ 

The Volcano HotEnd is the solution to slow printing. Boasting 3x the volumetric flow rate of the standard V6, Volcano enables you to print bigger and stronger parts, faster. If you've got a printer with a large build volume then the Volcano HotEnd is a must-have.

Customisable

The Volcano HotEnd maintains as much compatibility with the E3D ecosystem as possible. You can choose from a range of upgrades including temperature sensors and heater cartridges, as well as different nozzle materials and sizes for whatever use case you require.

Faster 

Thanks to its larger melt zone, the Volcano HotEnd enables users to print thicker and wider tracks which results in dramatically reduced print times.

Stronger

In addition to reduced print time, the thick tracks printed by Volcano have greater interlayer adhesion and bond to one another with improved strength. Parts printed are extremely strong, less brittle and feel much more sturdy than standard prints.

Bigger

With the print volumes increasing and interest of larger 3D printed items such as furniture and automotive parts, comes a requirement to decrease the overall print time. The Volcano heater block was designed to make printing large parts more efficient by allowing the use of larger nozzle sizes and higher volumetric flow rates.

Key features:

• 3 x the volumetric flow rate of the V6 HotEnd 
• E3D Ecosystem compatible
• Maximum printing temperature 285°C
• All metal heatbreak

Kit includes:

• 1 x V6 Heatsink 1.75 or 2.85 direct or bowden 
• 1 x Volcano aluminium HeaterBlock 
• 1 x Stainless steel HeatBreak 1.75mm or 2.85mm 
• 1 x Brass volcano nozzle 0.8mm 1.75 mm or 2.85mm 
• 1 x Heater cartridge 30W 12V or 24V
• 1 x Thermistor cartridge
• 1 x Thermsitor extension cable 
• 1 x Collet clip 1.75m or 2.85mm
• 1 x Collet clip 1.75mm or 2.85mm 
• 1 x V6 fixings kit 
• 1 x PTFE tube 
• 1 x V6 Fan duct 
• 1 x 30 x 30 x 10 mm fan 12V or 24V 
• 1 x M3 grub screw 
• 1 x M3 washer
• 1 x Thermal paste
• 1 x Volcano sock 
• 1 x Cable tie 

Buy an E3D Volcano hotend assembly from Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!