E3D Online

E3D Silicone Sock for Volcano Heater Block

(6 reviews) Write a Review
SKU:
VOLCANO-SOCK
  • E3D Silicone Sock for Volcano Block sensor cartridge - 3D Printer Spare parts
  • E3D Silicone Sock for Volcano Block sensor cartridge - 3D Printer Spare parts
  • E3D Silicone Sock for Volcano Block sensor cartridge - 3D Printer Spare parts
$2.50

Description

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

Replacement silicone socks for your Volcano HotEnd. This silicone sock is ideal for the E3D Volcano heater block.

Silicone Volcano socks offer a huge boost in temperature stability, this particularly important when using high-airflow cooling around the nozzle to cool the print.  The additional cooling, combined with reduced heat radiation from the block to the print really boosts the ability to print great overhangs and bridges, all while keeping the HotEnd temperature extremely stable.

Made from an inherently non-stick high-temperature silicone, these socks help keep your nozzles and block free from plastic residue.

While they are designed to be as durable as possible, they will eventually wear away or perish. Your mileage will vary depending on the temperatures used and the materials you print with.

Package Contents:

  • 1 x Silicone sock for E3D Volcano block

Buy an E3D Volcano sock from Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!

View AllClose

6 Reviews

  • 1

    Bad fit, and they don't last

    Posted by Dave on August 17, 2023

    No fault of spool3d, these are official ed3 socks, but e3d makes them like garbage. Very bad fitment, and after a couple weeks of printing they become brittle and just start crumbling apart into your prints.

  • 5

    Volcano sock

    Posted by Ian on August 23, 2019

    Fits perfectly and really great for keeping the end clean and temp stable.

  • 3

    fits better than V6

    Posted by Unknown on August 28, 2018

    it does fit better than V6, but still not worth the money and headache.

  • 5

    nice fit

    Posted by Unknown on March 14, 2018

    fits nicely, bought because when printing 1.2 mm with my volcano, could’n’t keep temp up. did not test again at high flow

  • 5

    Perfect for keeping heater blocks clean

    Posted by Edward Simpson on January 17, 2018

    Not sure why this isn't in the Eruption pack, but it's perfect for keeping the heater block clean. Also insulates to an insane degree, I made the mistake of touching the heater block with this installed and the heater at 200C, it barely felt warm on the outside with my finger in direct contact with the sock, so they're a great safety addition as well.

  • 3

    A little expensive, but works well

    Posted by Jason Znack on August 28, 2017

    Keeps the large surface area of the volcano clean and helps stabilize temps which is nice for when you're really pushing plastic.

View AllClose