Bondtech
Bondtech LGX™ Mounting Accessories
- SKU:
- BONDTECH-LGX-MOUNT-ACC-15108
- UPC:
- 7350011413973
- MPN:
- SKU: 15108
Description
Free shipping in Canada for orders over $140 before tax. (via Canada Post)
Extend the possibilities of your LGX™ with this mounting hardware set.
- Mount a plate in between the extruder and the stepper motor with the longer screws;
- Extend the mounting possibilities with the motor studs (up to 4 additional mounting points);
- Improve the Direct Drive performance with the PTFE tube (Sized for Copperhead).
M3x30 Low Head Screws recommendations:
Replace the M3x27mm screws on the 3 positions highlighted in the picture.
The M3x30 screws are compatible with mounting plates from 1 and up to 3mm thickness.
If mounting plate is 1mm thick, or thinner, use the default screws M3x27.
PFTE tube lengths:
Copperhead screw mount : 30mm
New Mosquito and Mosquito Magnum : 11 mm
Old Mosquito and Mosquito Magnum : 10 mm
PFTE cut recommendations:
PTFE tube should be cut straight on both ends.
Slight chamfer inside is recommended, but not mandatory.
Buy Bondtech LGX™ Mounting Accessories from Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!