BigTreeTech BTT TMC5160T Stepper Driver

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

TMC5160 is a control chip of high-powered stepper motors with MOS power expansion,20A maximum current and low heat generation.

StealthChop2 mode for TRINAMICs eliminates motor noise by reducing resonance.

StallGuard2 filament blockage detection enables stepper motor torque control or back to zero without a sensor, which is a safe detection of motor stopping and the replacement of mechanical stop switch.

DcStep allows the motor to run near its load limit and speed limit, achieving 10x or higher range without any pulse loss.

SpreadCycle is high precision chopping algorithm for highly dynamic motor motion and generating absolutely clean current waves. Low noise, low resonance and low vibration chopper.

CoolStep current control optimizes driver performance and energy efficiency, enables smooth and silent drive, balances speed and motor torque, reduces energy consumption by 75 %.

TMC5160 is an upgrade of TMC2100, TMC2130 and TMC5130 series, with higher voltage and motor currents.

High quality and ultra-quiet.  It is recommended to have active cooling.

• Stepper Motor of Chosen Type
• Heatsink

Buy a TMC5160T stepper driver from Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!