3M

3M 468MP x 5mil Adhesive Sheet - 200mm x 200mm (8 inch x 8 inch)

(7 reviews) Write a Review

SKU:: 468MP-200X200
UPC:
MPN:

$5.50

Current Stock: 234

Quantity:

Description
7 Reviews

Description

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

3M 468MP clear transfer tape uses an acrylic adhesive and can be used in the following temperature range: 5 C to 200 C. This adhesive tape has a 5 mil thickness. Products in this category features liners which you peel away to expose the adhesive material before applying to the 3D printer bed or PEI (polyetherimide)sheet.

Key Features:

5 mil (0.0052") thickness
Heat resistant and durable

Buy 3M 468MP x 5mil adhesive sheets from #Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!

View AllClose

7 Reviews

5
Good quality

Posted by Unknown on May 08, 2017

as advertized, delivery is prompt, happy to do business
5
It's stick!

Posted by Jonathan Gervais on April 20, 2017

The product is great, but be aware this is absolutely critical to take your time while applying, plan to buy more than one sheet, I ruined the first sheet I had ordered. Tips: 1. If you have to remove it from glass put it in an acetone or lemonene bath; 2. If you have to remove it from heated platform, remove the platform from the printer, put it in freezer overnight and carefully separate the PEI from the platform and use soaked paper towel in lemonene to cover the platform and put it in a plastic bag for 2 or 3 hours then scrape off the residues with a plastic scraper. If a lot of residues remain repeat the paper towel step. Finish of by rubbing with lemonene to remove any small spots of adhesive.
5
As Advertised

Posted by Reginald Mercure on April 17, 2017

Works great to glue that PEI Sheet to glass. Easy install, just take your time.
5
Sticks like crazy

Posted by Bryan Denny on January 23, 2017

Great stuff to fasten your PEI sheet down with.
4
It is what it claims to be

Posted by Mark on January 15, 2017

Works well to adhere a piece of PEI to the build plate. The dimensions were slightly smaller than the PEI I received but within a few mm so quite acceptable. You only get one shot to get this applied so be sure you are straight and avoid air bubbles. You can use a knife to 'cut' out air bubbles while the paper is still attached to the second side.
5
Great Adhesive

Posted by Ian on August 25, 2016

Goes down easily. Seems a little too easy to flop on itself when removing the protective paper.
5
THERE ARE NO SECOND TRIES WHEN APPLYING THIS

Posted by Leo on May 26, 2016

Do not peel back the tape on this once it is applied! It will just bubble. SUPER STICKY.