Description
Free shipping in Canada for orders over $140 before tax. (via Canada Post)
With this adapter, no wires need to be cut!! Simply connect this between your board and your cable, attach the 3 BLTouch wires and upgrade your firmware.
- Ender 3
- Ender 3 Pro
- Ender 5
- CR-10 Mini
- CR-10
Improved design with wider power channels
Ensure you connect BLTouch's 3 pins per the labeling on the board.
You must have a bootloader flashed to your Board in order to use this.
The pin 27 board makes installing a BLTouch or filament sensor fast and easy. Normally you would need to cut the ribbon cable and solder into the pin 27, but with this board it is plug and play after updating the firmware.
Make sure to check your wire configuration on your BLTouch or filament sensor.
- Swap the red and brown pins on your BLTouch cable - Red = 5V, Brown = Ground, Yellow = Signal
- Disconnect LCD ribbon EXT1 on the control board
- Connect EXT1 to the pin 27 board
- Connect BLTouch to the 3 pins on the pin 27 board
- Connect the pin27 to the main board. Make sure to align the header pins from the pin 27 to the main board.
- Connect the black and white lead from your BLTouch to your z-endstop board connection
What's included:
- Pin 27 board adapter board
Buy a pin27 board for your 3D Printer's BLTouch from #Spool3D online in Canada without the surprise cost of the exchange rate!
1 Review
-
It does the job
I installed this with my Ender 3 Pro and it worked perfectly, as expected.
Related Products
Related Products
PT100 Daughter Board
Duet3D
E3D PT100 - Board
E3D Online
Thermocouple Daughter Board
Duet3D
Spool3D PT100 - Board
SPOOL3D
Interface Board - Wanhao v1.7
Wanhao
Duet Expansion Breakout Board
Duet3D
AnyCubic TriGorilla Control Board
Anycubic
Spool3D PT100 - Board and Sensor
SPOOL3D
BIGTREETECH S2DW Accelerometer Board
BigTreeTech