Description
Free shipping in Canada for orders over $140 before tax. (via Canada Post)
Advantages
- Superior performance of MOSFET (Max 280A).
- Extra large heat sink , the maximum current can be up to 30A.
- Can use hot bed output signal of Ramp1.4 and MKS series to control .
- Can use digital signal of 5-24v to control .
Usage
1. Connect Power to power source, please note the anode and cathode.
2. Connect Hotbed to heated wire , please note the anode and cathode.
3. Connect digital control signal to Gnd,D8.
4. Connect the control signal of Ramps1.4 or MKS MOSFET to -Bed+
5. Choose one signal group to connect .
Buy an MKS 30amp MOSFET heating controller from #Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!
1 Review
-
Bed heats up much faster
I bought this because I felt that I was pushing far to much power through my printrbot power supply and control board. I use an old computer power supply to power my printer so this allowed me to use a separate supply rail to power the bed which results in faster heating.
Related Products
Related Products
MKS MOSFET 25 Amp Heating Controller
MKS
Lerdge Heated Bed Power Expansion Module MOSFET
Lerdge
Creality MOSFET
Creality
Creality MOSFET for Heatbed
Creality
Makerbase MKS Eagle 32-bit 3D Printer Control Board Kit
MKS
Makerbase MKS Robin Nano v3.1 32-bit 3D Printer Control Board Kit
MKS
Makerbase MKS Robin Nano v2.0 32-bit 3D Printer Control Board Kit
MKS
Stepper Motor Smoother - MKS
MKS
Stepper Motor Driver Heat Sink - Black
MKS