Description
Free shipping in Canada for orders over $140 before tax. (via Canada Post)
3 versions available:
- no wiring or thermistor
- wired for 12V with thermistor; wiring is 100cm long (direct replacement for Wanhao Duplicator i3 v2.1, etc)
- wired for 24V with thermistor; wiring is 50cm long (direct replacement for Wanhao Duplicator i3 Plus)
Product Features:
- 214 mm x 214 mm x 3 mm (L x W x H)
- Voltage: 12/24 V
- Power: 90W
Package Contents:
- MK3 Aluminum Heat Bed selected with no wiring/thermistor, 12V with thermistor, or 24V thermistor
Buy a MK3 aluminum heat bed from #Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!
6 Reviews
-
Flat, sturdy and a good fit, but low temperature
90W is not a lot and this bed struggles to get over 85c and at 12V it heats up SLOW, usually 30 minutes from 10c to 85c and I had to tweak my thermal runaway settings to get it that high without failing. It's good for PLA, but would not be suitable for higher temp plastics. I'm planning to over volt it to get more power out of it for faster heating times and higher temperatures. A higher Wattage would be much better.
-
Nice heat bed
Bought the pre-wired 12V version, it's solid and high quality, just needs some strain relief to avoid pulling the wires.
-
tooo expansive compared to other places
it cost me around 60$ to be delivered where you can find it on amazon for 19$
-
GOOD QUALITY
easy to install and nice quality
-
really nice heated bed
Bought to replaced an aging mk2, really happy with the purchase, heat up a lot faster then my old bed
-
Works great
Installed easily. Fit perfectly. Easy to solder. Heats up quickly, much faster than my old heat bed that failed.
Related Products
Related Products
MK3 Heat Bed 200mm x 300mm - 12/24V,
400mm x 300mm MK3 Heat Bed
Heat Bed Spring
Thermal Fuse for Heated Bed
Creality CR-M4 Heat Bed
Creality
Creality Cr-200B Heat Bed
Creality
Heat Bed Glass with Beveled Corners
SPOOL3D
Creality Ender 6 Heat Bed
Creality
Creality CR6-SE Heated Bed Assembly
Creality