E3D Lite6 Injection Moulded Fan Duct

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

If you need to couple a 30mm fan to a 22.3mm cylinder then look no further! The beautiful Lite6 fan ducts are injection moulded out of translucent red polycarbonate. They are much harder wearing than printed parts and because they are manufactured to tighter tolerances they are significantly less prone to vibration. 

These are exactly the same geometry part as the E3D-v6 Blue fan duct, but red.

These ducts are not compatible with v5 HotEnds. 

This duct is available for download as an STL on Thingiverse. Thing #340312.

This will not ship by lettermail as it is too large by height.

Buy E3D accessories in Canada without the surprise cost of the exchange rate!