Creality CR-7, CR-8, CR-10 MK8 Bowden Extruder


Create Wishlist

Colour *

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

Creality MK8 bowden extruder parts. Upgrade from the stock injection molded extruder on the following printers:

  • Ender 3 Series
  • CR-10/10S/S4/S5
  • Ender 5 Series
  • CR-7
  • CR-8

Buy a Creality MK8 aluminum extruder for your 3D Printer from #Spool3D online in Canada without the surprise cost of the exchange rate!



5 out of 5 (based on 7 ratings)
leave a review

A simple upgrade

Replaced the stock extruder on my CR-6 SE as lots of people complain it wears down too easily/quickly. This was pretty easy to install (definitely easier than re-assembling the stock one) and gives me a bit of peace of mind.
Posted by Alex, February 17, 2021

Wasn’t sure at first!

It comes with no instructions Which is odd but like everything in the world there’s a YouTube for that! What I wasn’t sure about was the fact you don’t use your tube “fitting” on the extruder you snap a little plastic piece in there and shove your tube in and install the little my surprise it grips that tube perfectly!!! On to the extruder itself, it’s very well made, easy to install and looks fantastic. Also as I was told it does in fact reduce stringing to a noticeable degree! Worth the money!
Posted by Brad, September 01, 2020

Awesome purchase

Was having nothing but problems with the stock extruder on my Ender 5, and this part immediately resolved the issues. Best purchase I have made for the printer.
Posted by Mark Prescott, May 05, 2020

A must to have

Great product, really improve your prints. Best 3D shop in Canada
Posted by David , September 24, 2018

Corrected my poor printing

I was having inconsistent lines on my first layer as well as random missing lines, bad adhesion. I replaced all "other" parts in the process but it wasn't until I replaced the Bowden extruder that my problems vanished. The original part looks brand new but it obviously has an issue.
Posted by B Matthews, May 13, 2018

Fixed my printing issues

I was hesitant to purchase without a spring adjuster but after installing my extruding issues were fixed. I also realized that installation of washers on the spring pin will create a incremental tightening of the spring so it is adjustable after all.
Posted by B MAtthews, April 27, 2018

Great product

I’ve been using this extruded since I got it. No more problems with skipping like the old one. It’s clean corners and smooth surface is a bonus. It was also very easy to replace.
Posted by Nadine Arcand, March 02, 2018