*TPE - 85A - 1.75mm 3D Printer Filament

This filament, while difficult to switch a hotend to, prints very cleanly with the highest consistency I've seen. Great uses include grip for handles, flaps for hand pump check valves & other seals (if finished by melting slightly against glass), and great for anything from sound-isolating feet/mounts to hard shoe bottoms depending on density. The soft-touch texture is also good for hiding the fact that a part is printed. If you're having trouble extruding, make sure the hotend handles similar hardness of TPU, but use 4-12in of cleaning filament, then take care to feel the filament pull into the extruder and release the tension if it stops pulling. Clear the nozzle occasionally since this won't mix with most other filaments. If it doesn't stick, use packing tape or gloop.

I would buy it again I have printed only a few things far but so far so good great quality for the price

I'm loving the prints with this filament, but getting it to stick to my BuildTak surface was difficult. I tried every combination of bed temperature and nozzle temperature I could but found turning off the bed heater and putting clear packing tape down over the BuildTak was the only thing that worked. After sorting that out it's been perfect.

good so far. i like the stiffness. printing well as well. could be interested in a bulk order soon. could you please return to me a price based on 10 rolls of 1.75 black and a price based on 50 rolls. Thank you gents...