E3D

E3D Groove Mount Bowden Adapter

$9.00
account.wishlists.heading

Create Wishlist

Close

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

This is a neat little solution for quickly and easily converting a direct extruder that would normally accept a groovemount hotend into a bowden extruder. Simply mounts in like a hotend, but instead accepts our PTFE tubing securely in an embedded bowden coupler.

Quite a bit nicer than forcibly screwing a threaded bowden coupler into a printed hole, and allows you to use the existing plethora of excellent direct extruders available in a bowden setup.

If you're designing your own bowden extruder you might consider using this to secure your tubing instead of a screw in coupler.

Engineering drawings can be found in the image gallery.

Package Contents:

  • E3D Bowden coupler for 1.75mm or 3.00mm filament
  • collet and clip

Buy a genuine E3D Bowden coupler from #Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!

SKU: M-GROOVE-###

Reviews

5 out of 5 (based on 3 ratings)
leave a review

Flawless

5/5
I purchased this to replace the one on my knock off e3dv6 which would not hold a tube at all. This one works flawless. the tolerances are spot on.
Posted by Chris Morgan, February 09, 2018

Fonttionne bien

5/5
Comme sur la photo
Posted by Roger, January 12, 2018

Groove Mount works exactly as expected

5/5
needed this to mount my titan into my D-Bot with a tiny bowden tube. I have the motor above the rail, lite6 Volcano below, with a short tube to clear. i could have printed one, but the tolerances are perfect, and locking the tube in with this saves any headaches.
Posted by Morgan L., November 07, 2016