Creality Ender 5 Plus MainBoard v2.2

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

The Creality Ender 5 Plus can use the Creality mainboard v4.2.2 with main chip GD303.  The following wiring changes need to be done to use:

• The screen connector on the board side needs to be flipped.  Either cut the 'keyed' portion of the connector to flip around, or flip around the mating connector on the board.
• The Tx and Rx wires need to be swapped in the connector on the display side (orange/yellow).
• The 2 z-stepper motor cables need to be made to terminate into one connedtor.  Either crimp together into one connector or use a dual z daughter board.
• The hotend cooling fan and main board cooling fan - need to cut the connectors off and install in the "fan" screw terminals.
• The BLTouch needs to be wired into the 5-pin BLtouch connector on the main board according to main board silk screen.

4.2.2 can be purchased here.  Please write in order comments this is for an Ender 5 Plus to confirm the chip type.

Creality Ender 5 Plus stock control board v2.2 with pre-installed firmware.

Silent motherboard version is v2.2.1

Buy a Creality Ender 5 Plus main control board for your 3D Printer from #Spool3D online in Canada without the surprise cost of the exchange rate!