SPOOL3D

MK8 Nozzle - Brass

$6.00

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

 

This MK8 nozzle is a drop in replacement for OEM Makerbot MK8 nozzles.

The MK8 nozzle represents an improvement over the previously used Mk7 nozzle. The main difference between the MK8 Stepstruder and the MK7 is the ratio of melted to unmelted plastic inside the heated nozzle. You don't want PLA to stay melted for too long, because it will start to degrade, but the MK8 design eliminates that problem. About the same amount of plastic fits into each nozzle, but in the MK8 nozzle, more of that plastic remains solid. That means that any given bit of PLA will spend less time sitting in the heated nozzle in it's liquid state, and won’t have much time to degrade.

This 0.4mm nozzle is compatible with the MakerBot Replicator 2, 2X, and 5th Generation Desktop 3D Printers, as well as some other brands of 3D printers.  It accepts 1.75mm filament.

Package contents:

  • 1 brass MK8 nozzle (Size 0.2mm, 0.3mm, 0.4mm, or 0.5mm diameter)

Buy 3D printer nozzles for your Makerbot in Canada without the surprise cost of the exchange rate!

SKU: MK8BR-NZL###

Reviews

5 out of 5 (based on 9 ratings)
leave a review

better nozzle than the original

5/5
replaced the original nozzle that kept clogging. This end seem to be more uniform in heat retention and dissipation. Haven't broken a piece of filament since changing over and the flow is very uniform.
Posted by paul herspiegel, January 29, 2018

as good as the original

5/5
installed easily as expected and performs well.
Posted by John, September 22, 2017

Brass nozzle

5/5
installed easy fits nice and tight against the barrel good choice good product
Posted by Ken Sterdan, July 11, 2017

Not disapointed

5/5
Great product and great customer service.
Posted by Richard Cleveland, December 29, 2016

Just perfect!

5/5
These nozzles work great, I have no complaints!!
Posted by Francois Lemay, November 28, 2016

nozzle appeared to be clogged

2/5
Filament curled immediately upon install. Not sure what the problem was, we dont have time to troubleshoot a $3 part. Just bought another one from someone else.
Posted by undefined, November 24, 2016

perfect fit

5/5
works perfectly
Posted by undefined, September 13, 2016

MK8 Nozzle

5/5
Great
Posted by undefined, May 04, 2016

Upgrade nozzles

4/5
To date this new configuration to replace the original Makerbot nozzles has been trouble free and I keep a few in stock in my print shop so I'm never stranded or stopped mid print. I normally just put in a new one for any big job.
Posted by John, November 02, 2015