Micro Swiss All Metal Hotend Kit for Flashforge Finder and Flashforge Guider 2

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

This is an all metal hotend upgrade kit for Flashforge Finder and Flashforge Guider 2.  The all metal hotend will let you print at much higher temperatures than possible with the original PTFE lined one. Another benefit of an all metal hotend design is more consistent melt chamber control. During slow extrusion rates in a PTFE lined hotend, the transition zone from solid to molten plastic tends to creep upward creating more stringy prints. With the all metal design, a transition zone is always constant, being located right at the heat break. With fast extrusion rates, the PTFE tube doesn't have enough thermal conductivity to properly melt all of the plastic coming out.  The ll metal hotend solves this problem, plastic is surrounded by a thermally conductive nozzle throughout its length.

Orifice size available: .2mm, .3mm, .4mm .5mm, .6mm, .8mm, 1mm, 1.2mm

Kit includes:

• 1 Plated Brass Wear Resistant Nozzle - 0.4mm
• 1 Thermal Tube
• 2 Jam Nuts (To aid in removing old hotend)

• FlashForge Finder 
• FlashForge Inventor 2
• FlashForge Guider 2 (Older version, without metal plate over the heater block)
• FlashForge Guider 2S
• Dremel 3D40 Idea Builder

Installation Instructions

Buy Micro Swiss products in Canada without the surprise cost of the exchange rate!