Free shipping in Canada for orders over $140 before tax. (via Canada Post)

This kit does not include a motor.  E3D recommends the  'Compact but Powerful' motor.

The E3D Titan Bracket can downloaded from Thingiverse. 

Performance, power, push. Titan brings high performance, lightweight extrusion. All the benefits of geared extrusion in a lightweight, punchy little package. Titan can be mounted on most RepRap 3D printers to improve extrusion and is the recommended extruder for all our HotEnds. For a full Motion System, you'll need 2 x 1.75mm standard bowden Titan's with motors, plus 2 mirrored versions.

Performance

By using a 3:1 gearing ratio, precision milled hobbs, and an adjustable idler lever, Titan is a powerful extruder whilst also being lightweight and compact.

Power 

The 3:1 gear ratio means you’re able to use lighter motors as you’ll need less torque for the same filament pushing force - so direct drive setups have a lighter moving carriage, and bowden setups become powerful, reliable printers when combined with an E3D V6 HotEnd.

Versatile 

Titan works well for all configurations ,bowden, direct, 1.75mm and 2.85mm. To switch between filament diameters, all that’s required is to replace the filament guide and the bowden adaptor/ HotEnd.

Speed 

Extruders with high gear ratios often fail with rapid retracts and struggle with keeping up with the Volcano heater block. Titan’s balanced gearing ratio of 3:1 means that you can cope with fast extrusion situations like Volcano and the lightweight gear-set gives snappy retractions.

Resolution 

Direct drive extruders can have issues with ‘pulsing’ flow due to the lower resolution of the gearing and hobb teeth, this can result in a wavy surface finish, becoming particularly prevalent when printing with low layer heights. Using a 3:1 gearing ratio triples the resolution of the system, allowing smoother printing at the lowest of layer heights, using the smallest of nozzles.

Key features:

• 3:1 gearing ratio
• Individually cut, sharp hobb teeth
• Direct or bowden 
• Standard or mirrored
• Groove mount slot

Kit includes:

• 1 x Titan body standard or mirrored
• 1 x Titan Cover standard or mirrored 
• 1 x Idler lever standard or mirrored 
• 1 x Filament Guide 1.75 or 2.85, standard or mirrored 
• 1 x Steel Pinion Gear
• 1 x Hobb drive 
• 1 x PTFE tubing 100mm 
• 1 x 1.5mm Hex Wrench
• 1 x 2mm Hex Wrench
• 1 x 2.5mm Hex Wrench
• 3 x M3 x 30 Screws
• 1 x M3 x 8 Screw
• 1 x M4 thumbscrew
• 1 x M4x10 button head screw
• 1 x M4 Nut
• 1 x Idler spring
• 1 x M3 grub screw
• 1 x Shake-proof washer

Documentation

• Assembly Instructions

Buy an E3D Titan Extruder Assembly from Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!