300°C Thermistor by Slice Engineering

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

High Quality Component

• Capable of reading from room temperature up to 300°C.
• 15mm long, 3 mm diameter cartridge. A standard for sleeved thermistors.
• 2m long bare leads.
• 5mm long filler shaft.

Use in conjunction with Boron Nitride Paste for the highest accuracy results.

*NOTE: Installation of a new thermistor will require selecting the correct sensor in your firmware settings. Some printers may require an update of the RT table in the printer firmware, especially for the 450°C Thermistor. Not all 3D printers allow firmware updates. Please check to ensure your printer will allow firmware updates, otherwise the thermistor will not work.

Buy a 300°C Thermistor by Slice Engineering from Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!