MKS MOSFET Heating Controller - 3D Printing Canada
MKS

MKS MOSFET 30 Amp Heating Controller

$16.00

Create Wishlist

Close
Current Stock: 16

Free shipping in Canada for orders over $140 before tax. (via Canada Post)

 Advantages

  • Superior performance of  MOSFET (Max 280A).
  • Extra large heat sink , the maximum current can be up to 30A.
  • Can use hot bed  output signal of  Ramp1.4 and MKS series  to control .
  • Can use digital signal of 5-24v to control .

 Usage

1.  Connect  Power  to power source, please note the anode and cathode.

2.  Connect  Hotbed to heated wire , please note the anode and cathode.

3.  Connect digital control signal to Gnd,D8.

4.  Connect  the control signal of Ramps1.4 or MKS MOSFET to -Bed+

5.  Choose one signal group  to connect .

Buy an MKS 30amp MOSFET heating controller from #Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!

SKU: MKS-MOSFET-30AMP

Reviews

5 out of 5 (based on 1 rating)
leave a review

Bed heats up much faster

I bought this because I felt that I was pushing far to much power through my printrbot power supply and control board. I use an old computer power supply to power my printer so this allowed me to use a separate supply rail to power the bed which results in faster heating.
Posted by Ryan, April 06, 2017

Related Products