Free shipping in Canada for orders over $140 before tax. (via Canada Post)

 Please read available online resources for connections. We are not responsible for board damage that is caused by being misinformed.

MKS Gen-L v2.1

The MKS GEN-L v2.1 makes setting up UART and SPI mode easier with jumper caps rather than external wiring required with the v1.0.

Features:

• Arduino MEGA compatible Atmega2560 and FT232 processors are compatible with all RAMPS class firmware
• Firmware can use the same configuration as ramps1.4
• Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board
• Easy connect MKS TFT on AUX-1
• All extra pins broken out the same as ramps1.4(AUX-1,AUX-2,AUX-3,Servos1)
• 3 x temperature ADC connectors for thermistors
• Up to 5 motor driver with easy micro stepping setup (micro switches)
• 4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed,Extruder0,Extruder1, Fans)
• 4 layers PCB, optimize heat dissipation.
• 3 x 5V output, 3 x 12V-24V output interface.
• 6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
• Recoverable fuse for short-circuit protection.

MKS Gen-L Github

Package Contents:

• MKS Gen-L v2.1 circuit board
• 5 x MKS TMC2209 v2.0 Stepper Drivers and heatsinks
• jumpers

Buy an MKS Gen-L v2.1 and Stepper Driver Kit from Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!