Micro Swiss All Metal Hotend with SLOTTED Cooling Block for Zortrax M200
Free shipping in Canada for orders over $140 before tax. (via Canada Post)
This is the Micro Swiss All Metal Hotend kit for Zortrax M200.
This upgrade includes a modified thermal barrier tube and modified nozzle with modified cooling block. Thermal barrier tube is made from 2 different materials. The lower thermal break is made from stainless steel, the colder upper part is made from aluminum. Stainless steel was used for the thermal break because it offers low thermal conductivity, and aluminum was used for the upper portion (cold end) because it has much better thermal conductivity, to carry away any heat from the filament into the cooling block. The all metal hotend will let you print at much higher temperature than possible with original PTFE lined one. Another benefit of an all metal hotend design is a more consistent melt chamber control. During slow extrusion rates, in PTFE lined hotends, the transition zone from solid to molten plastic tends to creep upward creating more stringy prints. With an all metal design, a transition zone is always constant, being located right at the heat break. With fast extrusion rates, the PTFE tube doesn't have enough thermal conductivity to properly melt all the plastic coming out. On the original extruders, that limitation happens around 60 mm/s, depending on nozzle size. The all metal hotend solves this problem, plastic is surrounded by thermally conductive nozzle throughout its length.
Fits:
- Zortrax M200
- Zortrax M300
Kit includes:
- 0.4mm Brass Plated Wear Resistant Nozzle
- Thermal Tube
- Slotted Cooling Block
- Custom screw
- Allen Wrench
Buy a Micro Swiss All Metal Hotend kit for Zortrax M200 in Canada without the surprise cost of the exchange rate!