Free shipping in Canada for orders over $140 before tax. (via Canada Post)
This option is ONLY for the Makerbot 2x extruder. It has a deeper cooling block and a wider mounting hole spacing (78.5mm).
Developed by the inventor of Ninjaflex
Flexible filament extruder retrofit kit for both left and right sides of a dual-extruder printer. Print fast with flexible materials, higher resolution, and fewer failures. Also prints ABS and PLA better than your stock extruder.
*Does not include stepper motor.
Flexible filament extruder retrofit kit for dual-extruder direct-drive machines, such as Flashforge Creator. The Flexion extruder will allow full-speed printing of ultra-flexible filaments. The precision machined components allow your printer to push on filament harder, achieve high pressure in the nozzle, and control feed rates very closely. The self-cleaning drive will keep your long prints from failing due to a clogged drive. Works will with Ninjaflex, Filaflex, flexible PLA, TPU, TPE ultra-flexible filament down to 50 Shore A, and all the standard rigid filaments like ABS and PLA.
This kit requires you to disassemble your printer’s extruder and reinstall this upgrade.
The Flexion Extruder is designed to fit as many models as possible – please see installation instructions for more details.
Makerbot Replicator 2x. See the Flexion support page for information on retrofitting to your printer.
- Mounting block
- 2x Tensioning arm with idler and cleaning brush (one right and one left)
- 2x Adjustment cam
- 2x Drive gear
- 2x Feed barrel
- 2x Heater block
- 2x Insulation for heater block
- 6 nozzles – 2 each 0.3, 0.4, 0.5 mm orifice
- 2x Adapter shim to allow 6mm and 0.25″ heater cartridges
- 4 PTFE feed tubes
- 2 spare cleaning brushes
- All mounting hardware
- 6mm and 7mm wrench for installing nozzles
- “Flexion inside” quick-guide sticker
Note: does not include stepper motor or motor mounting screws
Buy a Flexion Extruder Kit from #Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!