Great fan
5/5
I did the same as a previous reviewer, Im actually impressed with how much air it pushes out, its quite a bit more than the original fan.
12V Cooling Fan - Ball Bearing - 40mm x 40mm
$7.00
Current Stock:
29
Free shipping in Canada for orders over $140 before tax. (via Canada Post)
- Size: 40mm x 40mm x 10mm
- Voltage: 12V
- Startup Voltage: 6V
- Current: 0.20A
- 7000 rpm
- CFM: 7.02
- Static Pressure m(Inch-H2O): 4.51
- dB-A: 33
- Weight: 14g
- Cable Length: 70cm
- Ball Bearing
Package Contents:
- 12V Model 4010 Cooling Fan
Buy a cooling fan from #Spool3D for your 3D printer in Canada without the surprise cost of the exchange rate!
SKU:
BB-FAN12-4010
Reviews
leave a reviewGreat fan
5/5
Needed to replace the hot end fan on my 3D printer. This fan is quieter and pushes more air than the original fan.
Sounds like a jet engine but works like one too.
5/5
It works great on my i3 clone hotend. Very loud but extremely powerful.
Great Quality
5/5
This is a great fan, I'm completely a fan!! Haha The noise level is far less than my previous one and it seems to have a lot more power.
Good replacement
5/5
Replaced the original fan that had a couple of the blades missing. This is a direct fit, quiet, and provides better airflow. My printer is more consistent with the filament feed since the replacement.
Nice QUIET Fan
5/5
I needed to replace the fan on my extruder cooler as a couple of the blades had broken off. My old fan was (even pre-broken fins) quite loud. This new ball bearing fan is a great upgrade
Works fine
4/5
Quiet fan and lower nice amperage draw. The cfm is not terribly high, but it does the job to provide ample blow on your prints.
